Max. standard width

up to 20' (6096 mm) depending on gauge and slat type 

Max. standard height

up to 20' (6096 mm) depending on gauge and slat type 

Mounting

Intererior or Exterior face of wall

Curtain

Interlocking roll-formed slats, end locks attached to prevent lateral movement;
22 gauge galvanized steel;
Curved Profile type C-187 for doors up to 15'4" wide;
22 gauge galvanized steel; Curved Profile type C-275 for doors up to 20' wide;
22 gauge galvanized steel;
Flat Profile type F-265 for doors up to 20' wide; 22 gauge galvanized steel;
For fenestrated service doors, provide slats w/ 3” x 5/8” uniformly spaced openings (18 gauge C-275) (18 gauge F-265)

Bottom Bar

Two primed, black painted angles
(min. thickness 3/16”) with 2-wire, self-monitoring, fail safe, electric sensing edge with yellow/black striped vinyl cover

Hood

24 gauge galvanized steel primed, black painted; interior hood baffle included

Brackets

Min. ¼” hot rolled primed, black painted steel

Guides

Structural primed black painted galvanized steel, 1/4” min. thickness

Operation

Direct drive hypoid gear motor/brake assembly (20” per sec up speed / 12” per sec down speed); drive assembly and limit sensors are factory pre-assembled; manual crank for power outage

Control Panel

Variable frequency drive controller with self diagnostics (time delay self close timer and non-resettable cycle counter included); two line LCD readout, enclosure NEMA 4X rated

Door Roll

Direct driven, springless roll with integrated shafts; self aligning greasable sealed bearings; door does not require counterbalance device

Safety Devices

Photoelectric sensors; 2-wire black/yellow striped electric fail-safe sensing edge; automatic stop-lock brake

Actuator

Single open/close/stop push button station incorporated into Control Panel

Curtain Finish

Gray or tan powdercoat with “anti-graffiti” hardening additive

Windload

20 psf when wear strips are not specified